Gateway of last resort is 10.70.21.2 to network 0.0.0.0 According to the routing table, the router will route 0.0.0.0/0 to 10.70.23.2 as the default route is learned via RIP as denoted by the R* Gateway of last resort is 10.70.23.2 to network 0.0.0.0ġ0.0.0.0/8 is variably subnetted, 8 subnets, 4 masks O - ODR, P - periodic downloaded static route Ia - IS-IS inter area, * - candidate default, U - per-user static route I - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2
![default router configuration default router configuration](https://1.bp.blogspot.com/-jYaQPSgovKM/W97RgB21SNI/AAAAAAAAAGU/bu2TUVTv14k0mBC35zzNGorYymsLKicuACLcBGAs/s1600/adver.png)
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2Į1 - OSPF external type 1, E2 - OSPF external type 2 – Verify that the default route is properly propagated from R3 to R2 and R1 by viewing the RIP database and routing table on R1 and R2.
#Default router configuration free
!# Free CCNA Workbook Lab 7-7 R3 Initial Config #
![default router configuration default router configuration](https://ciscofriend.files.wordpress.com/2011/11/asa-static-default-routing.jpg)
!# Free CCNA Workbook Lab 7-7 R2 Initial Config #ĭescription # FRAME RELAY LINK TO R1 #ĭescription # FRAME RELAY LINK TO R3 # !# Free CCNA Workbook Lab 7-7 R1 Initial Config #ĭescription # PHYSICAL FRAME RELAY INTERFACE #ĭescription # FRAME RELAY LINK TO R2 #
![default router configuration default router configuration](https://i2.wp.com/networkustad.com/wp-content/uploads/2019/08/show-ip-route-router2.png)
In this lab you will configure R3 to advertise a default route throughout the RIP routing domain.įamiliarize yourself with the following new command(s) Command This lab will continue to build upon the same logical topology used previously in Lab 7-6 as shown below This command is default-information originate Utilizing this type of configuration can a company money due to the man hours required to configure a static default route on each and every router and/or switch in the network and that does not include general router/switch maintenance.Īdvertising a default route via RIP is done by a single command that is executed in RIP router configuration mode. RIP has a built in feature in which allows it to advertise a default route to its direct neighbors which will propagate throughout the entire RIP routing domain. Ideally a network engineer would not want to go to every single node in the network to configure a static default route so generally they would use a dynamic routing protocol to advertise the network 0.0.0.0/0. So lets say you have a boundary router that has a direct connection to the internet and you want RIP to advertise the internet as a route known as a “default route”.